The KUPO SW-02 is a lightweight PVC-jacketed safety wire for smaller fixtures and lighter entertainment accessories. Its 2.0 mm 7 x 7 galvanized steel core is covered to approximately 3.0 mm overall diameter, helping protect both the wire rope and the fixture surface from abrasion and marking.
Why It Matters
Small fixtures still need a clean secondary safety solution, but a heavier cable can be awkward or visually excessive. The SW-02 keeps the cable light, adds a protective PVC jacket, and gives crews a 5 kg Working Load Limit (WLL) option for compact equipment.
Key Features
2.0 mm, 7 x 7 galvanized steel, 3.0 mm with PVC jacket wire rope construction gives the safety cable the right balance of flexibility and strength for entertainment fixture retention.
5 kg Working Load Limit (WLL) supports secondary safety use when matched correctly to the installed equipment.
70 cm length gives crews enough reach around common yokes, pipe positions, and fixture hardware without excessive slack.
aluminum ferrule termination and steel snap hook with eyelet provide a ready-to-use connection for typical lighting safety points.
Steel wire rope conforms to EN 12385-4.
Applications
Use for smaller lighting fixtures, lightweight effects units, compact accessory positions, and stage or studio equipment where a jacketed safety wire helps reduce surface marking.
Compatibility
Use only with static equipment within the 5 kg WLL, attached to approved safety points and inspected before use.
Frequently Asked Questions
Is the SW-02 meant to lift equipment?
No. This safety wire is for secondary retention of static equipment only. It is not a hoist, sling, or lifting device.
How do I choose between this safety wire and a heavier model?
Start with the equipment weight, site rules, and the required Working Load Limit (WLL). This model is rated at 5 kg, so move to a higher rated safety wire when the fixture or accessory requires it.
Does the finish affect the basic safety function?
The PVC jacket helps protect surfaces and reduce abrasion. It does not make the cable suitable for heavier loads, so always select by WLL first.
Choosing a selection results in a full page refresh.
